Sulsaly

AI-powered hardware identification and electronic component analysis for engineers

by Discovered

The image shows a **6-pin (2x3) connector**, most commonly used in electronics for communication interfaces and power delivery. Depending on the context of the device it is attached to, it is likely one of the following: ### 1. JST-XH Connector (Most Common) If this is from a battery pack or a small circuit board, it is likely a **JST-XH** connector. * **Common Use:** These are standard for **LiPo (Lithium Polymer) battery balance leads**. A 6-pin XH connector would be used for a **5S battery pack** (5 cells + 1 common ground). * **Pitch:** The pins are typically spaced **2.50mm** apart. ### 2. Generic 2.54mm Header/IDC Connector If the pins are wider apart, it is a standard **0.1" (2.54mm) pitch** header. * **Common Use:** Used in Arduino, Raspberry Pi, and hobbyist electronics for connecting sensors or modules. ### 3. Custom Industrial/Peripheral Connector In some older hardware or specific industrial equipment, these are used for: * **Small Peripheral interfaces** (like old keyboard or mouse connectors). * **Custom PCB-to-PCB connections.** ### How to identify it for sure: To figure out exactly which one it is, you can: 1. **Measure the pitch:** Use a ruler or caliper to measure the distance from the center of one pin to the center of the next. * **2.50mm** $\rightarrow$ Likely JST-XH. * **2.54mm** $\rightarrow$ Standard header. 2. **Check the device:** If it's attached to a battery, it's a balance lead. If it's on a motherboard, it's a signal header.